Hey whats up guys! a buddy and i put a motor in my car i got off red96rs. GREAT! motor, good deal... good guy to deal with.

Anyways, to the point. got everything hooked up... took out A/C got a shorter belt. NOW! my car makes this squeal... like a bubbly squeal! almost like its spitting fluid out. This only happens when i rev it a little.

At idle... theres nothing. However, when i rev it via throttle body and listen. its just too hard to tell where its coming from.

Is there anyone out there with any ideas?! Thanks!

Edit: The tensioner pulley above the hydrolic thing. The pulley on the block was replaced brand new. The one on the head has 139k miles.


2gnt (period)

maybe air in the p/s system?

-MIKE-

Stroked 2.2L

so none of this started until AFTER you took off your a/c components? how do you have it bypassed? install an idler pulley or just a belt from crank to p/s? I'm just kinda confused because your second comment (edit) refers to the timing belt stuff. I was gonna suggest pulling your p/s belt first, then running it to see if it's still doin it, then your alt belt. If it's doin it after that, I'd maybe go with air in your coolant system, but not sure what all a 'bubbly squeal' would sound like...

/>

'95 GS w/ t3/t4b
FMIC, diy piping & RFL BOV
MS2-Extra Fuel&Spark
50 lb/hr Holley injectors w/ 1:1 RRFPR
JE 8.8:1 dish w/ Hastings Rings
Eagle Rods w/ ARP bolts
ARP Head studs
Mild port/polish head
3" custom DP/cat section, 3" PIT catback
dual MBC - 12 psi / 20psi