Where can i get an engine already forged and have everything already upgraded to handle high boost conditions.. because i dont want to rebuild but if that is the only way to do then it looks like it.

Concept Illusions, Howell Automotive

buy/sell/trade section on these forums

-Keith

'92 BMW 325i - 3.91 LSD....Cold air intake....M52 headers.....Track pipe....Remus back....Fan Delete....UUC short throw...M3 Clutch Flywheel & Drive Shaft...Tien Coil overs

I <3 the twisties

There is only one way to get a fully forged internals in an engine and thats with a howell stroker kit. However you can purchase the callies crank in the kit seperate and use your choice of stock length forged rods and forged pistons of your choice as well. If you order through howell they can assemble it all up for you and deliver it to your door, although very expensively.

Yeah Howell is probably the only company I would go through. CI motorsports has the 420a's already built but with there poor customer service I've heard about, I wouldn't go that way with my engine. You can find them on here sometimes along with ebay. But its all about preference. Yes howell is expensive but they're reputable.

- 98 Eclipse rs turbo

Edited..... this is not a place to advertise

Build your own, why is that so hard. Most machine shops can order the parts for cheaper than you can normally purchase them anyways. I had my whole bottom end replaced with forged internals and the machine shop only charged me $1200 for parts and labor.

-Alex

That isn't an oil leak; it's sweat from all of that horsepower.

We have shortblocks, long blocks, or you can build a rebuild kit however you want it. If your willing to wait a bit our shortblocks usually take 4-6 weeks to ship.

www.cimotorsports.net