Ok guys,
As some of you may have seen in a few posts, I bought a non running ESi with a new motor in it. Well I was told by the kid it ran fine when he picked it up and now it doesn't start...

This is what's happening and what I have checked list..

Checked...
Cam sensor (no voltage)
Crank Sensor (no voltage)
Firewall relays
all fuses and relays under hood and dash
Checked the coil pack and there is no signal
Fuel pump does not prime

The only thing I can think of is that its the ECU.

Can anyone tell me anything else to check, I'm running out of ideas and the junk yards around here won't refund my money if it's not the problem.

Proud Owner of a few Check Engine Lights...I mean eclipses.

1997 Eclipse Gs Heavy mods
1998 Eclipse Rs Daily driver
1995 Talon ESI ( Doesn't run )
1997 Eclipse GS ( Doesn't run )

if is 95 then probably your ecu is bad . U check the asd relay right?

I agree on the ECU. Mine did the exact same thing before I changed it this last time.

1995 Eclipse GS 2.0 non-turbo 5 spd 174k + miles

is your check engine light on when u turn the key on if it is check for the codes .

The check engine light doesn't come on at ALL...and I did check the bulb...it's good...just NEVER comes on!! I even hooked up my snap on scan tool and it just doesn't connect..


Proud Owner of a few Check Engine Lights...I mean eclipses.

1997 Eclipse Gs Heavy mods
1998 Eclipse Rs Daily driver
1995 Talon ESI ( Doesn't run )
1997 Eclipse GS ( Doesn't run )