I am trying to trouble shoot my car not starting. I have a mt 98 eclipse with hrc turbo system with 88,000 miles. I have been runing my turbo since 2003 and i had about 56,000 when i installed. I have been using my manual to try and see why my car is not starting. I have checked my fuel system,asd/mfi relays, spark plugs,coil and have even changed my crank sensor. My car ran fine last week until i went to start it and it started up and ran for about 30 seconds. After the car shut down i tried to start it again but i have not had any luck. It has tried to start for a couple of seconds but that is about it. I even went to auto zone to get a tester and i am getting a pass on the tester. Today i went under my car and disconnected the lead going to my crank sensor. I did the check that the hanyes manual said to do but i am not getting the 9 volts that i should be getting. Does anyone know where the center wire of this connector leads to at the terminal of the ecu plug? I would like to do a continuity check before i try and yank that harness out of the wire shielding. Any help would be great!

98 rs,HRC stage 1,,custom interior, painting, 17 inch konig imagine rims , install, powerstop rotors,Pro 1 exhaust,tokiko 5 way adj.