I have a 5-speed out of a 95 that the bearing stop on the case for the input shaft has broke during disassembly. I can reweld in the 3 pieces if someone can tell me what the diemension should be from the step from the bearing ring or the outside surface of the case. Or could someone put me in the direction of a place to get of that kind of info. If I can fix this and you have had this problem drop me a e-mail and I will help you out.

Are you referring to the three tabs that keep the reverse synchro or brake synchro cone from spinning? IF you can tig weld them, then just weld them where the breaks are.

IF you dont want to deal with that i have a case i can sell you that just needs one of the threaded holes helicoiled. Its one of the holes from the bearing plate.

Terry

The 3 tabs are on the bearing plate end of the input shaft bearing on the inside of the case. Also if I can not fix this how much for the case?

Your referring to the alum tabs on the case? They are not located on the actual shaft.

if you want the case i have...... since one bolt thread needs to be helicoiled....20.00 shipped.

I will take the case. How would you like payment? Money order,paypal etc.

PM sent

I did not get your PM

resent