I got the 02 neon trans. I am going to swap the levers and mounts, is there anything else i need to swap? Speedo gear? if so, how do i do that? and i ordered the spec stage 3 modular clutch to fit the 2gnt, it should fit right in correct guys?
#3856, "RE: I GOT THE NEON TRANNY, now what?" In response to Reply # 0
If it has the sensor you may have to swap it i am not sure but if you do then just remove it and pope the little gear off the sensor and it clips on to your sensor. I thought the 02 neon sensor was the same as ours.......check autozone website for part numbers to be sure.
Bellhousing is the same, swap the levers if they are different and the mount you should be good to go. I cant remember but i thought the 02 shift levers worked fine.....i have only worked with the first gen neon tranny but congrats good find Mike.
#3858, "RE: I GOT THE NEON TRANNY, now what?" In response to Reply # 2
whats the benefit of an 02 tranny?
USED TO HAVE...Everything you wish you had, and then some...
You are somebody special Tim, you matter! - from the admins (but nobody likes you, because your username is just like that other guy's, and you whine a lot)
#3859, "RE: I GOT THE NEON TRANNY, now what?" In response to Reply # 3
Originally posted by tim97rs whats the benefit of an 02 tranny?
i just bought it because i got a 02 neon trans for $500 shipped with only 5,600 miles on it rather than paying the $750+ for eclipse tranny's with 80+ thousand miles on them. better deal and from what i searched and read, better for boosting. so terry, the speedo gear is actually on the sensor?
#3860, "RE: I GOT THE NEON TRANNY, now what?" In response to Reply # 4
Absolutely mike. there are two gears, one on the Diff (speedo ring gear), one on the sensor. they are a mated pair, therefore the sensor gear on your 394 tranny will not mate to the speedo ring gear in the 355 tranny. The sensor should be the same, i am pretty sure.
Does the Neon trans have the counter weights on the shift levers? If it does then you need to either cut the weights off or swap levers. I have read about people cutting the weights off.
Give me a ring tonight or tomarrow if you need, after 6pm my time 7pm yours.
#3861, "RE: I GOT THE NEON TRANNY, now what?" In response to Reply # 5
Well for the shift levers they may have to be switched and the mount too. As for the speedo gears though IIRC you use the neon sensor and the gear. Now if you don't have the sensor then you will need to switch. But if you have both the sensor and the gear then you just do the wireing.. Don't quote me on this though. I know I will have to change the gears when I switch because I have to swap the quaife so....
I edited to the wiki!
Originally posted by DR1665 NOTE TO SELF: Go commando to wedding. Scar the Irishman for life.
#3864, "RE: I GOT THE NEON TRANNY, now what?" In response to Reply # 7
Originally posted by siueclipse
Originally posted by tim97rs whats the benefit of an 02 tranny?
its still the 3:55....
Actually if i recall the 02 tranny is spec'd to handle 10ft/pds of torque over the 394 and previous designs. There was a page on the main site detailing it but i cant find it now.
#3865, "RE: I GOT THE NEON TRANNY, now what?" In response to Reply # 8 Jan-11-05 04:00 AM by siueclipse
Originally posted by Star Turbo Talon
Originally posted by siueclipse
Originally posted by tim97rs whats the benefit of an 02 tranny?
its still the 3:55....
Actually if i recall the 02 tranny is spec'd to handle 10ft/pds of torque over the 394 and previous designs. There was a page on the main site detailing it but i cant find it now. Terry
#3866, "RE: I GOT THE NEON TRANNY, now what?" In response to Reply # 9
Originally posted by siueclipse
Originally posted by Star Turbo Talon
Originally posted by siueclipse
Originally posted by tim97rs whats the benefit of an 02 tranny?
its still the 3:55....
Actually if i recall the 02 tranny is spec'd to handle 10ft/pds of torque over the 394 and previous designs. There was a page on the main site detailing it but i cant find it now. Terry
James sometimes i think you are so dense its not funny. I know its a 3:55 did i ever say it wasnt? It has a capacity of 165ft/lbs of torque while the 394 has 135ft/lbs. where does it say in my posty that a neon trans is not a 3;55. I was installing a 3:55 while you were still asking what the point of it was!
#3863, "RE: I GOT THE NEON TRANNY, now what?" In response to Reply # 0
Originally posted by eclipse982nrRST I got the 02 neon trans. I am going to swap the levers and mounts, is there anything else i need to swap? Speedo gear? if so, how do i do that? and i ordered the spec stage 3 modular clutch to fit the 2gnt, it should fit right in correct guys?
honestly... i spent almost an hour with you on aim answering these questions, did you bother to write any of it down?
don't bother asking me for any help in the future.
#3869, "RE: I GOT THE NEON TRANNY, now what?" In response to Reply # 12
james you said the tranny would bolt right up. you said you didnt know about the speedo sensor and you said the cluthc 'should' fit. i was asking for a direct answer instead of 'maybe' and 'should' answers. i said thanks for your time when i talked to you, chill out bro. i only asked the questions you werent for sure on bro
#3892, "RE: I GOT THE NEON TRANNY, now what?" In response to Reply # 14
Originally posted by Ducking_Fumbass And, I don't want to help anybody who would run off to ask Siu... That's, like, 3 strikes, before I even talk to you.
hey go fuck yourself. i explicitly told him everything anyone has said here about this subject. he chose to do continue asking the same question.
#6488, "RE: I GOT THE NEON TRANNY, now what?" In response to Reply # 15
I'm glad you all are so excited to discuss this topic. There is a lot of text here so I have a question I can't seem to get a direct answer to. With the 2002 tranny swap complete, what is the max MPH our cars can expect to reach? given the engine has the correct mods to bring it to top speed? (whatever that may be) in a reasonable time frame.
Search
Printer-friendly copy
1 User in Chat
