well the install went fine except for I managed to break a the top left bolt on the shifter plate. Any Ideas on how to get the rest of it out?

with 3 of those metal bushings in plus the sleeve bushing its amazing how much of a difference it made. Recommened to everyone.

Good Luck
______________________________________

I also have one installed on my Talon and it made a big difference. Add a B&M with 50% throw reduction and your set.

nice

______________________________________

11.65 @ 115

If there's enough to get a vice grip on with the shifter plate out of the way you might be able to twist it out. If not pprobably have to drill into it, and use an extractor.

Off to the manual trans section.



15.9 @ 86.7mph

Smooth idle? We don't need no stinking smooth idle.

Mods List:
http://highlander.dsmpower.com/sig.htm

thanks. "Extractor" I should be able to find it at any hardware store right?

Good Luck
______________________________________

i have one of those, it kicks ass! i'm thinking about taking my shifter out and cutting it shorter and welding it back together.... when i get around to it

__________________________________
-Ryan

Yup any hardware stoe,. I personally love Sears!

Just drill out the center of the bolt with the right size drill and use the right size extractor.It thread in reverse and cuts into the drill hole to grab it and turn it out.



15.9 @ 86.7mph

Smooth idle? We don't need no stinking smooth idle.

Mods List:
http://highlander.dsmpower.com/sig.htm