Hey guys has anyone done this add-on:

<b>Venom 400 Performance control module</b>

The VENOM 400 constantly monitors the vehicles throttle position senor (TPS) and manifold absolute pressure (MAP) or air mass sensor (MAS). When airflow entering the engine and the throttle position sensor reaches a predetermined level, the VENOM 400 is activated. The VENOM 400 then enters a strategy of sense and modify. It senses the sensor values, interprets them, then modifies them to increase performance. The existing on-board computer senses the modified values and increases fuel flow, modifies the ignition spark curve and transmission shift point (on automatics only). Once the sensor valves return to normal mode (like idle), the VENOM 400 switches back to sense only mode until conditions again warrant the high performance mode

^is that like aem's ems?

Site: http://www.eautoworks.com/html/ORD-1-1-1-5187.cfm

//Patrick//

"http://www.dsmtuners.com/forums/image.php?u=21491&dateline=1097211642"

Patrick
Naples, FL

its a piece of shit that does nothing at all.
its like doing the tps mod, thats it, no it wont modify shift points either

1998 dodge avenger 4 cyl AT
Mods are:
Not enough

Ditto...don't waste your money. If you notice the graph in their advertising...it shows power gains at 50% throttle, but nothing at 100% throttle. That right there should be enough to seriously question the validity of this device. It will likely make your car feel faster around town, but do nothing for your peak power output.

see also http://www.whythevenom400istotallygay.com

Corbin

'95 ESI-T
HRC+FMIC+ETC...



Gimme fuel...Gimme fire...Gimme that which I desire