|
Throwing this out there because I could use the money, and I don't have time nor the money for it anymore. The interest and passion just isn't there like it once was and priorities in life have changed.
1997 Eclipse GS - 5spd manual - Roughly 60k miles on motor, over 100k on chassis/trans. I can get more accurate numbers if needed. The car has been kept out of the elements (winter months) in my parents barn and more recently in the garage of my home. The car is I would say 97% rust free. There are some chips, scratches, paints getting old/faded in spots, but still an eye catcher when driven. Each year in the Spring it fires right up and is driven occasionally during the warmer seasons and has made several trips to the DSM Shootout in Ohio without a hiccup. The car was obviously built for a high HP turbocharged setup and it's ready for one. I never got that far. The car has performed tremendously for me over the past 8-9 years it has been built. A lot of time, money, and effort was put into building this car and it has been a tremendous learning experience understanding the ins and outs of it.
For a feeler to test the waters, I'm going to start by asking 4250 OBO, I will be negotiable, but also know I don't have to sell it, so no lowball offers, or payment BS. Money talks, bullshit walks. If interested, send me a PM.
Mod list as follows, this covers the the majority, there may be some smaller ones I am forgetting.
The short block was professionally built by VT Competition and Engine development out of Lansing, MI. The block was hot tanked, and balanced/blueprinted. The head was built by ERT out of Chicago, IL.
Megasquirt 2 EFI
Innovate Motorsports MTX-L Wideband O2
8.8:1 CR Custom CP pistons
Eagle rods
Block balanced & blueprinted
IJ crankscraper
ERT custom race port & polish
ERT/Port & polish intake manifold
SS 1mm oversize valves
Crower valve springs w/ titanium retainers
5 angle valve job
2.4 PT Cruiser lifters/rockers
Crower stage 2 cams
Fidanza adj. cam gears
Prothane pass side and trans mount
XtremeRS solid front roll stop mount w/ upgraded bolt diameter.
AF/X UDP
EGR removal/blockoff
Crane Firewire plug wires
Screamin Demon Coilpack
ARP header studs
Tsudo 2.5" N1 knockoff Exhaust w/ 60mm Magnaflow resonated test pipe
Tsudo 4-1 Header
Injen short ram intake
MP/x Manual IAC
Fidanza Short throw shifter
Energy suspension shifter bushings
Technafit SS Clutch line
Nuespeed front tower brace
Rear Pilot tower brace
Tokico HP(blues) struts/shocks
Tein S-tech springs
$15 Rear camber mod
GSX front caliper upgrade
RRE SS brake lines
Brembo blank rotors
metal master pads
215/55/16 Yokohama S-Drives put on in April 2013. 90-95% tread remaining.
I contributed to the Wiki.
|
