|
Well just finshed buliding a new sub box for the old lady's new car. Yesterday we went and picked out some subs and I already had a new amp so I said I'll just let her use it to power the subs. But looks like the amp I have is not enought to power the subs properly before I go and exchange amps and shell out the extra cash I like to make sure. Here what I'm looking at..
400 Watt 2-Channel Power Amplifier with Built-In Crossover
Features
PWM Regulated MOSFET Power Supply
Bridgeable 1/2/3 Channel Capability
Balanced Isolator Input Circuit
Oversized Screw-Type Power/Ground Terminals
Screw-Type Speaker Terminals
RCA Inputs
Hi-Volt Input Level Control (200mV-6.5V)
Speaker Level Inputs
Selectable Crossover: 80Hz, -12dB/oct. (LPF)
Specifications
Continuous Power: 75Wx2 (4 Ohms), 100Wx2 (2 Ohms), 200Wx1 (4 Ohms)
Peak Music Power: 400 Watts
Frequency Response: 10Hz - 50kHz (0,-1dB)
Total Harmonic Distortion: 0.008% (1kHz, 4 Ohms)
Signal-to-Noise Ratio: 100dB (IHF-A Weighted, at 1Khz)
Dimensions: 10-7/16" x 1-15/16" x 9-5/16"
Infinity Reference 1020w 10" Woofer Sensitivity: 90db Power handling: 250w RMS Requency Response: 22~800Hz Nominal Impedance: 4ohms
Looks like I don't have enough amp to hold those subs, but what if I bridge the amp and run in the subs Parallel.
We had two bags of grass, seventy-five pellets of mescaline, five sheets of high powered blotter acid, a salt shaker half full of cocaine, a whole galaxy of multi- colored uppers, downers, screamers,laughers... Also a quart of tequila, a quart of rum, a case of beer, a pint of raw ether and two dozen amyls.
|