k just wondering if anyone had a schematic off hand or knew what the easiest way to set this up is. i'm gonna be using a single output to control the windows through my alarm system (viper 500). basically i'm gonna set it up so when it sends the signal, the windows go down. the next time the signal's sent the windows go up. i know this makes things a lot more complicated. as far as the relays for the windows themselves i don't think that should be too hard.. should be just like how the regular switches in the car work. one relay for up, another for down. (being that you gotta change the direction of current). what's the easiest way to alternate where that signal from the alarm is being sent? i just need it to send the signal to the 'down' relay the first time, then the 'up' relay the second time. i'm jsut tryna think what the simplest way is... hmmm.. hehe at least havin aftermarket power windows makes wiring a little easier. (especially since i ran the switches into the center console instead of the doors).

anyways any ideas would be appreciated. hehe i'm just havin fun getting the most out've those extra output channels on my alarm. too bad i didn't have another channel to turn on my stereo an stuff... hehe should've gone w/ the viper 800...

-marc

='95 RS 5spd Red=
CAI
A'pexi N1
Hanabi 9000k HID
SPAL Deluxe Power Windows
Nakayama GT5 17's
GSX Calipers
AEM Rotors

255 is fricken short