I have a DEI Avital Avistart 3000 in my car, WORKED fine. But then i just took out my alarm because it was acting funny. Anyway, i was pretty careful to make sure i only unhooked the alarm wires and i was pretty sure thats all i unhooked because all the alarm wire were clumped together and tied and they all came down when i was finsihed.
Anyway, now when i hit the remote start, when it is suppsed to start the engine, i hear 6 or so very quick clicks that it powers down and does the same thing over again. Could I have accidentally unhooked a necessary wire? I checked the accesssory wire and the igntion wire(inside my steering column cover right by the key hole) that my alarm was hooked up to and the alarm wires were the only thing that were hooked up to them were the alarm wires. But i know the installer of my DEI could have spliced the wires anywhere from the ecu all the way to the igntion. And im not sure this is my problem even.

So anywy, what i wanna know is...what should i check? Again, i hit the remote start, everything powers up, the car beeps a few times like it always does wehn you put the key in the start postion and then the DEI im assuming tries to turn the car over but all i hear is 6 fast clicks and then it powers down and repeats the process.

Thanks for any help!

----------------------------------------------------------------------------
home.comcast.net/~nappyjim/songs.html
home.comcast.net/~7291834avi/carputer/carputer.html
www.cardomain.com/id/napppyjim

*Proud Member of the Top Ten Post Whore Club*
*Proud And Co-Founding Member Of The Zoom Zoom Revolution*
nappyjim-3 Chip-0
No one likes you chip, go away.