Hey all, im just about finished with my sub box, and am about to install my amps. How have all of you ran your power wire back from the battery, and the wires from the head unit back? im using a 4g power and need to run it to the back along with the rca's and remote. How should i do it? any suggestions would be helpful, thanks in advance.

Chris
97 Red GS

run the power cable on one side, i used the left since it was easier from the battery.. and run the rca's on the right side.. if you run the powre wire on the same side as the rca's .. you'll get distortion.. and if you were asking how to get them there.. just pry up the plastic piece by the door, it snaps back in, then you could either take out your seats a little bit or just stuff the wires down into the side and bring it around to the back.. also, i'm not sure if other peoples seat's are like this, but in the back of mine, by wear they bend, my back seats have little hooks in them so watch out..