I want to replace the factory dash speakers. The manual says they're 3T which I take to mean 3 inch tweeter. But I can't seem to find anything to fit the stupid thing. I read a post in general forum, and somebody said to just get aftermarket tweeters and mount them. What size would I need to make them look flush with the hole in my dash. thanks

Heather

95 RS, AFX Underdrive Pulley, Front and Rear Strut Tower Braces, Front Lower tie bar, OBX Header, Final Drive Mod, Konig Traffic rims with Kumho Ecsta Supra Tires, Accel Spark Plug Wires, Dynomax Exhaust, Optima red top Battery, Air Intake, Z3 Fenders (T

got to any stereo shop and ask them if they have any plates that would fit in there, cause what my shop did, was take a 3" piece of plastic that had a 1" cut out for a tweeter and mounted it like that

got my 1" tweets in there no problem.. fit is perfect and was very easy to do.

^^what once was^^


^^what is now.. and permanently^^

1" kicker tweaters baby!

"Only Pirates Say R"
hondahater21@hotmail.com
www.geocities.com/hondahater21

Change Your own Blinker Fluid! --> http://geocities.com/changeyourblinkerfluid/

Most tweeters you buy come with the flush mount and angle mount cups as part of the package. All you gotta go is cut a hole to the size of whatever the specs call for and drop the cup in there and your good. If you wanna keep the stock look then you can always pop out the factory tweets and then rig the new ones in from underneath, it's not hard and you can use a ton of different things to mount them up so you can keep the stock speaker grill look....