OK, First off, It didn't work very well, secondly, This is just a prototype. I wanted to mess with it by hand before I go stupid and get it cut properly and everyhing. There are a few bugs to work out so in time I will Finish.

First off I need to use thicker plexi....like 6mm stuff. also the front of my bumper in the middle has an indentation....


This is how it first started off. I got a good pic of it and vectorized it to exact measurements. So far soo good. Now I'm gonna cut this bitch out with a very fine blade in the jigsaw.







Now this is after it has been cut out and not sanded.....just a test fit. Again so far soo good.....except for the fact that I want it to come out about another inch or so in the front and about half that on the sides.


Now this is what I got.....not impressed. The bottom of the bumper has this bend in it.....ghey IMO so WTF do I do now.....




Once again this is JUST A PROTOTYPE! I had to see what problems I would run into before getting any extensive work done and its a good thing i did this.


So Anyways, The next step is to get some opinions from you guys.

My buddy doesn't really like the idea. but I do. Use your imagination a bit. It will be a lot smoother and more precise. I don't put crappy shit on my car.

Comments??

I eat emo kids for breakfast

1995 Eagle Talon (SOLD)
72' SuperBeetle
72' Standard Beetle
56' Deluxe Beetle