#36093, "RE: Question for RSConversion" In response to In response to 11
thats not cool I only have 4 points lol
Anyways here is exactly what I did for my spoiler holes. I bought some steel from a place that specializes in auto body paint and tools (you should have one near you just ask them what they recomend). I forget what gauge it was but it was still flexible but decently thick. For your holes cut a peice that is a little bigger then the hole and tape it under the hole from the inside of the car (yes the tape will catch on fire make sure you blow it out). From the outside spot weld it in place. Make sure you do not over heat the metal as it will warp very easily! Grind down any welds that are higher then the body panel itself. After that apply bondo and sand repeat untill it is perfect. I would also recomend you primer the inside where you just welded bacause the heat will cause the paint to come off and it can rust over time. That should be about it. I hope it makes sense and good luck.
BTW I would like to thank RSconversion for PMing me and not doing it on the board. I sent you my apologize for starting shit on the board and not PMing you like I should have. Your a better man then me because of this. Sorry.