O.k., I'm to impatient to wait for someone else to do this (with this being my very first mod to the car...besides switching out the stock headlite bulbs for some from Hiper Industries...), so I went ahead and did it by myself...hope this helps some of you...leave me some feedback!!!

Here is how I went about doing my install on my '95 Talon ESi w/ Cruise control...

1. Checked out HadesOmega's install (to get an idea of what I was getting myself into)...he has good pictures on his site of what the components look like and also the sizes of bolts, and the 65 ft/lbs. torque measurement...worth checking out!!! Actually...I recommend it before you even start this!!!

http://www.imagestation.com/album/?id=4291960891

2. First things first...pop the hood and look around...make sure you have the necessary tools...I used:

10 mm socket
11 mm socket
13 mm socket
17 mm socket
WD40
Breaker Bar
Torque Wrench

And keep the plastic on the bar...will make for a clean install.

3. Loosen up the battery tie (13 mm) and bring it as much forward as you can

4. Locate the brake fluid resevoir (between 2 relays and the windshield washer fluid resevoir). Replace the upper 2 bolts (I believe these were 13 mm) with bolts, washers, and spacers that came with the bar...starting from the firewall, it should go...SPACER, MOUNT, WASHER, then BOLT.

5. See those two relays (ignition relays???) next to it?...disconnect them (either 10 or 11 mm) and bend the mount ever so slightly so when you hook the relays back up...they will be tucked under the firewall just a bit, don't forget to hook them back up!

6. Get those big nuts off (17 mm) of where the bar will be mounted. This is where I used the breaker bar and some WD40...those nuts were on there pretty darn good...

7. Now if you try to fit the bar, you'll notice a problem with the washer fluid resevoir...most people just take that bolt out and leave it out, but I thought...if you have spacers for the brake fluid resevoir...why not the washer fluid too??? I found a bolt with the same head size, but about 1/2 inch longer (or so...), grabbed 1/2 inch spacer and some thin, small washers...and just experimented for awhile with the spacing...now I'm able to keep the washer fluid resivoir just in front of the bar, so I can still fill up the bottle!

8. Now position the bar...it should clear the cruise control box(I had absoluetly no problems with it...it's just sitting on it, I think) and make sure everything else clears. If not...better fix it up now...

9. Put the bar all the way on and grab the Torque wrench...65 ft/lbs. for the big nuts...I went from 45 to 55 then finally to 65...just to be sure they get on there all the way. Now the bar is installed!!!

10. Last notes: Remove the plastic wrap carefully...and you're finally done!!! Took me about 2 1/2 hours to finish up everything (including the experimenting)...why are you still sitting here reading this...take your car out...show off your stuff and test drive it!!!


I really hope this helps everyone out...and post this up on the BIG 2GNT.com web site for everyone to see, please???...any other questions...feel free to e-mail me!

William 'Tha.Will' McGroarty

~*Roary*~
Sick Skillz