...so this weekend i'm going to finish up my cluch/LSD installation. right now, i have everything disconnected on my transmission except the axles and the bolts that hold the bellhousing to the engine block. shifter cables, speedometer sensor, reverse gear sensor, clutch slave cylinder, 4 flexplate bolts, front and rear motor mounts, it's all removed/disconnected.
i've been trying to figure out how to disconnect the suspention components to be able to do the axles. so far i've removed the huge 32mm nut that holds the axles to the hub, but i have no idea what to do next. i've never worked on my suspention before... so what do i need to disconnect to be able to pop the axle out of the differental? pictures are good...
