#825, "RE: Mitsu Ignition Transistor module install pics" In response to In response to 4 May-17-05 03:42 PM by XtremeRS
Originally posted by DR1665 Where did you make it?
In my garage Haha, but really, all it is a piece of 1/8" thick aluminum, about 3x3.5 inches, and some aluminum L angle found at Home depot in 4ft lengths(.75x.5 inch, 1/16 thick). I just put one piece of L anlge on top of the other, to make the "fins". Then drilled 2 holes for each fin, and used machine bolts/nuts to hold them on. Used machine bolts/nuts again to hold on the Transistor module. I used heat sink compound on the back of the trans module, and between the L angle pieces. Used 2 self tapping screws to hold it to the strut tower. Hmm thats it!
But it is almost overkill for this module though. This sucker doesnt even get barely warm at idle haha..
13.5 @108 MPH-2.2 60ft(stupid FWD!) S16G @ 18 PSI/FMIC/Running on MegaSquirt II (Now with sequential fuel injection) My webpage: http://eclipsed4evr.home.comcast.net -1998 Mitsubishi Eclipse RS-T- "Toy" -1992 Plymouth Laser Turbo AWD(SOLD) -2000 Honda CR-V(daily)
Haha, but really, all it is a piece of 1/8" thick aluminum, about 3x3.5 inches, and some aluminum L angle found at Home depot in 4ft lengths(.75x.5 inch, 1/16 thick). I just put one piece of L anlge on top of the other, to make the "fins". Then drilled 2 holes for each fin, and used machine bolts/nuts to hold them on. Used machine bolts/nuts again to hold on the Transistor module. I used heat sink compound on the back of the trans module, and between the L angle pieces. Used 2 self tapping screws to hold it to the strut tower. Hmm thats it!
