well ive finally started tuning somewhat. im still waiting for 2 relays to wire up my starter and fuel pump. I plugged in my laptop and have been exploring all these things i can do with the ecu. It literally blows my mind. I entered my REQ_FUEL values and got 2.8. i followed the megamanual and am setting all the basic engine constants, ignition characteristics, and ignition settings. Then i will try to start it, but i was wondering where in this process i enter any information about the fuel im using. I plan on using e-85. Sorry if this information is going to be covered later but i dont want to get ahead of myself, it just seems like something that should be done before starting the motor. Also, i have no throttle cable hooked up right nowm and fully closed it reads 11% open, and when i manually open it all the way it reads 76% open. Is this a bad connection? Also, i recieved this throttle body completely dissassembled and maybe i put it together wrong? i know the pin on the tps can go in more than one way, could this be my problem? it just seems like if it was in wrong it would read over 100% or hit 100% early if it reads 11% when closed. I see there is a TPS calibration under tools, is this what i need to do?