Crank Pin 1: Yello 8v Refernce ------5 Volts Vref from Ms Pin 2: Black /Green- ground ---GROUND Pin 3: Blue whgiite: signal---- IGN from Ms (shielded wire)
VSS: Yellow: 8v Refernce ------5 Volts Vref from Ms Black /green - ground ---GROUND Yellow/white tach signal ---goes under dash to white tach wire
TPS BROWN / RED- Signal ----tPS SIGNAL ON ms Green yellow- 5v power ------5 Volts Vref from Ms
cOIL: BROWN: coil 2-4 -----brown wire on Ms BLack/blue Coils 1/3 -----green / white stripe wire on Ms Black red - 12V or ASD relay. ----12 V or wire this to the ASD relay ill have to build?
It says brown on ms diagram to coil 2-3, shouldnt it be, 2-4? and same for the other wire, where it says 1-4, shouldn't it be 1-3?
IAC this one idk, shouldnt there be a power and ground? or is this just resistance based?