#3384, "RE: Running MSnS v3 Board as FULL Standalone (No Spikes)!" In response to In response to 15 Aug-30-07 12:55 PM by WickedESi
Hate to do this... but read the bottom of the first post:
Originally posted by WickedESi Tuning the MS Pots - To tune the crossover point (R52) disconnect your fuse on your ASD supply wire. Crank the car, turn the pot 1 revolution clockwise till the crank RPM dissappears, then note how many it was in that direction. Then do the same in the other direction, then put it in the middle.
- Leave the hysteresis pot at zero to 1/4 turn for the most stable signal. If you happen to get any noise crank this clockwise until it vanishes (too much and your signal will dissappear completely).
Glad you're at the fun part now!
Joel Baldridge, ASE Certified Master Technician, Audi Certified Expert Technician