all i want is essentialy a unit to run my 8-inj set-up WITH intake temp control. i do not want to use the full stand-alone capabilities of the MS, i just want primary and secondary injector control with air temp corrections being able to be made automaticly.

can this be done? if so, do i get the MS and just wire up the injecter dirvers and intake temp sensor and leave all the other stuff alone?
or is there an alternaitve to gettin the whole MS shebang, and still accomplish my needs?
here is a link to my origional post on this, FYi:

http://forums.2gnt.com/dcboard.php?az=show_topic&forum=54&topic_id=696&mesg_id=696&page=2

USED TO HAVE...Everything you wish you had, and then some...

You are somebody special Tim, you matter! - from the admins (but nobody likes you, because your username is just like that other guy's, and you whine a lot)