so this is the story:


The car stopped getting spark after i washed under the engine bay (i know, i know). I have tested the spark plugs on another car and they are fine, i have put a test light on the wiring harness into the ignition coil and it gets power when the engine turns but i have no measures the voltage, i have tested my ignition coil and the resistance is in spec. I did a spark test and there was no spark.

I put a test light from one of the outputs in the coil that the plug wires hook to and grounded it while turning the motor and the test light did not show any power.

I carb cleaned the crank sensor (it was so dirty) and re-installed, still no spark. cam sensor is brand new, took it off and it looked just fine.

any more ideas?

I have yet to:

-measure voltage into coil pack


help?