#96561, "RE: about the accessory pulley..." In response to In response to 14
Originally posted by 2point4 following the directions supplied by partsdino, at step 14 "rotate the installation shaft with 1/4 inch square key until the spring tang (see fig 3) alings with the arm nomial position notch, see fig 6. my notch is about 3/8 away from the spring tang alignment and it will not go any further. i've loosened the retainment nut and tried all sorts of rotations but still nothing further. anybody else have this problem?? wtf??
Did you loosen the nut and then turn the plate clockwise until it stops? Then put the belt on and try it, mine aligned perfectly after doing that. But you said you were following the directions, and if that is the case... I don't know.
If the engine is still in the car and you have another person helping you, here is a great tip: That rubber plug/grommet in the fender well, take that out, when I did it gave a PERFECT view of the alignment tang on the tensioner.
