Ok so im getting ready for my build on the bottom end. and i been doing research, but i would like to hear some opinions on the best way to go about building it. i bought a spare block that was pretty messed up. just about all the rod bearings were melted to the crank or rods. so in other words im trashing the crank. becuase the journals are messed up. but beside all that. what should i tell the machine shop to do when i take it in. i want it hot tanked, bored .20 over. but what else should i tell them to do to the block? and possible the crank when i get the new one? All your opinions are greatly appreciated. thanks
285 horsepower/269. torque at 11 lbs boost(e-85tuned) stock internals.