#9064, "RE: AT/MT swap almost done, except for this little switch..." In response to In response to 5
That was spot on correct. Reverse lights are good to go. I don't think I would have been able to sort that one out, certainly not quick. There are some significant differences between the diagram you sent me, and the one that I have. Nowhere in the backup light diagram I have is there a relay, only the ball switch. Go figure? I never did locate a physical relay (A-71 on your page), but I did locate the ONLY white with red stripe wire behind (A-77) 60 pin connector, so that should be a solid piece of info that will get it done for everyone. Thanks again for the solid info. Wanna take a crack at the clutch safety switch? It will only start with the clutch pedal out, instead of in. Easy right?