#5012, "Had trouble installing South Bend DXD clutch"
The threaded bolt holes didn't line up with the coresponding holes on the drive plate. The first bolt was fine, but then the next three went from roughly 1/8" to 1/4" off. I probably should've sent the POS back to South Bend but I elected to take a die grinder and notch the holes wider on the drive plate. Hopefully it'll still be centered once we get the tranny up in there. If the tranny-to-block bolts line up just fine then it should be ok. If not then we'll get our money back and get a ClutchMasters. $500 for a clutch and it should NOT be this much trouble to install. I won't buy from South Bend again, regardless of how well this clutch performs.