#1106, "RE: ATTN: Matt D. - Fidanza Part# Non-Modular Flywheel that bolts to the flext plate" In response to In response to 9 Aug-01-03 02:58 PM by XtremeRS
The CM pressure plate will bolt right up to a Luk or Sachs modular flywheel(thats what we have stock). The guy who built my clutch just drilled out the rivits of a stock modular clutch, and then built a custom 6 puck cermaic facing disk, then bolted it together. All the pressure plates are the same..actually I believe CM and Spec, ect..use a Luk or Sachs stock pressure plate and modify it, for higher clamp load #'s. But a non mod, and mod flywheel will both bolt up to the CM pressure plate. I'm pretty sure the disk will be ok for fit too..i not 100% positive, but i think its the same size diameter as the stock setup..i dont see why it wouldnt be.. I just worry about the strength of our flexplates..Oh yeah, i can have the trans out and on the ground in about an hour and a half now hahah.. Much easier and faster than what you guys have to put up with
13.5 @108 MPH-2.2 60ft(stupid FWD!) S16G @ 18 PSI/FMIC/Running on MegaSquirt II (Now with sequential fuel injection) My webpage: http://eclipsed4evr.home.comcast.net -1998 Mitsubishi Eclipse RS-T- "Toy" -1992 Plymouth Laser Turbo AWD(SOLD) -2000 Honda CR-V(daily)