Ok guys Im doing it today finally . I dropped the pan already cleaned the pan drilled the hole for the drain plug set the magnets. Now the fun part . Before I remove the valve body I want to make sure I remove everything that needs to be removed. I know that I need to disconnect the shift linkage but if someone could clarify that a little more for me I would apreciate it. Also I only see two sensors the input and output below that I see some wire harnesses but no sensors. I just dont want to end up breaking shit by pulling it with something connected. Thanks in advance guys.
#1048, "RE: Quick HELP with Shift kit" In response to Reply # 0 Jun-01-03 06:34 AM by soulcontroller
sand the hell out of the shift rod from the engine bay with some really fine grit sandpaper. i had a hell of a time trying to drop my valve body because there was a liiiittle bit of dirt on that rod, and was getting hung up. as for disconnecting the stuff from the rod, there is just one or 2 bolts you need to undo that are connected to that rod, that hold the shift linkage to it.
there should be 1 or 2 electronic connectors that you disconnect from the tranny in the engine bay as well.
______________________________ Matt D. '06 Evo IX SE '98 RS-T 13.8 @ 106.1
#1049, "RE: Quick HELP with Shift kit" In response to Reply # 1 Jun-01-03 07:37 AM by amljbs
http://www20.brinkster.com/amljbs/tranny.jpg
This is what I have thus far do I need to remove any other
sensor other than the one I show as removed.
Also the car is in neutral at the moment will that work or
should I put it in first.
#1050, "RE: Quick HELP with Shift kit" In response to Reply # 2
yea, it looks like youve got all the sensors. you should
really clean up the shift rod though. i thought i did a
decent job on mine, and it was reaaaally tough to get out. i
cleaned it up once it was out and it went back in no problem.
you may want to have a friend just watch from above to make
sure nothing gets hung up.
good luck!
______________________________ Matt D. '06 Evo IX SE '98 RS-T 13.8 @ 106.1