#104077, "just installed 315cc injectors and 8.7psi WG spring and....."
so today i got in my brand new 315cc injectors thanks too frank130 and there now installed as along with my new 8.7psi spring(7.7 technicaly after volume loss)so its time to drive the car and see how it runs,my supporting fuel mods are the 315cc injectors/vortech fmu/255lph fuel pump/safc/and wideband 02/(I oredered a fuel pressure guage as well but its not in yet:(.So i set safc to all zero throughout the rpm range figuring id still be rich,well I accelerate half throttle and WB starts reading between 10.0 and 10.9 at HALF throttle it gets to about 4000 rpms and falls completey on its face bogging so i correct the fuel trim just a tad to lean out especially around 4000 and up and fuly got on it and it seemed to pull worse then partial throttle but i only messed with leaning out only a few dagress till I talked on here and asked if someone else has this setup and how much i can lean on the safc before I start advancing timing too much,but theres one more concern,each time i boosted I only hit 5ish psi?is that because its bogging out?I hope I dont have to save up for a sfmu instead of fmu so can my setup save this bogging rich madness?oh and i was thinkin aint I supposed to do the stock fuel pressure regulator mod where you cut off the nipple on the end since mines a 95?please rescue me so i dont have to go back to my old setup at 5 psi
#104078, "RE: just installed 315cc injectors and 8.7psi WG spring and....." In response to Reply # 0
Yeah, too rich. As you should know by now, the safc doesn't allow to change fuel settings under boost in our cars and to start off, you are running stock idle fuel pressure on 50% larger than stock injectors. It's not a particularly good combination as you're finding out. Honestly I'd say you're better off running 5-7psi on stock injectors until you get an sfmu setup. I'd also say sell the safc to help fund the sfmu.
I contributed to the Wiki! EVO IX - just a really expensive boost gauge and a K&N air filter 96 Eclipse RS -awaiting registration and inspection 95 Eclipse GS - parts car Mods/Profile - http://www.2gnt.com/index.php?d=cs82685
#104079, "RE: just installed 315cc injectors and 8.7psi WG spring and....." In response to Reply # 1
would i max out my duty cycle on my stock injectors if i put them back in at 7.7 psi boost?if not I may be able to get away with that.Or possably run a 10-1 or 8-1 spring?I dunno*shrugs*thanks for input so quikly btw
#104080, "RE: just installed 315cc injectors and 8.7psi WG spring and....." In response to Reply # 2
Originally posted by spooled420 would i max out my duty cycle on my stock injectors if i put them back in at 7.7 psi boost?if not I may be able to get away with that.Or possably run a 10-1 or 8-1 spring?I dunno*shrugs*thanks for input so quikly btw
From my experience, my car was leaning out past 7psi. Not sure what you mean by a 10-1 or 8-1 spring? Assuming you mean disc for your fmu and that you currently have a 12:1 disc, then it definitely wouldn't hurt the matter.
I contributed to the Wiki! EVO IX - just a really expensive boost gauge and a K&N air filter 96 Eclipse RS -awaiting registration and inspection 95 Eclipse GS - parts car Mods/Profile - http://www.2gnt.com/index.php?d=cs82685
#104084, "RE: haha figures......" In response to Reply # 5
well I put in my stock injectors and ran it on the rich side of safc to be safe and lone and behold my psi is set at 6 psi,those ebay fuckers must have sent me the 7psi spring intead of the 8.8 so i got everything tuned around 11-12 afr till I can get some more gass and try to tune for 11.5 afr.I figured somthing was up when my car bogged like that bad under boost with the 315's.Well I guess from here ima contact the people I got the spring from and see if they can hook me up with the right one,thanks for the replys peeps.
#104085, "RE: haha figures......" In response to Reply # 6
Originally posted by spooled420 well I put in my stock injectors and ran it on the rich side of safc to be safe and lone and behold my psi is set at 6 psi,those ebay fuckers must have sent me the 7psi spring intead of the 8.8 so i got everything tuned around 11-12 afr till I can get some more gass and try to tune for 11.5 afr.I figured somthing was up when my car bogged like that bad under boost with the 315's.Well I guess from here ima contact the people I got the spring from and see if they can hook me up with the right one,thanks for the replys peeps.
Or you have a boost leak.
BTW, IDK what you are 'tuning' but you cannot tune with an safc under boost in our cars. Your best bet is to leave it as is for now until you get something that actually has some proven tunability on our cars, then put the larger injectors back in.
I contributed to the Wiki! EVO IX - just a really expensive boost gauge and a K&N air filter 96 Eclipse RS -awaiting registration and inspection 95 Eclipse GS - parts car Mods/Profile - http://www.2gnt.com/index.php?d=cs82685
#104094, "RE: haha figures......" In response to Reply # 8
well i ran the 315cc injectors and my car ran off he charts rich and started bucking,im thinkin ill need a 8-1 or maybe 10-1 disc for my fmu?what do ya think?
#104096, "RE: update" In response to Reply # 9 Aug-17-08 06:45 PM by spooled420
ok so this isthe setup at the moment,so far im running stock injectors @7.5 psi and ive got 5k-7k rpms around 11.4 and richens up to about 11.0 by 6600 rpm @ WOT, but from 3k-4k im runiing 12.4 afr WOT and cant richen those rpms anymore with safc but 12.4 doesnt seem too lean since its at such a low throttle rpm im hoping.ive researched the safc and everyone says that "leaning" on safc increases timing so the most i leaned was around -13 at 6k -7k so doesthis sound like a safe tune for you fellows since i didnt lean very much but did add alot of fuel trim in the lower rpms so whats your thoughts?