#5309, "MSNS Install " Jun-27-11 11:55 AM by Wes Tank
Sorry for garbaging up the forum with another MS thread but I will be finally doing the install on my talon from my previously build thread since my engine in broken in now. Just looking for any tips/tricks any of you have come across with your installs that might help me with mine. Picked up this unit (http://forums.2gnt.com/dcboard.php?az=show_topic&forum=16&topic_id=119500&mesg_id=119500&page=) from xcasbonx.
Thanks in advance.
_____________________________________________ 95TalonOwner on DSMTuners.com Wes Tank on WiDSM.org
And in the future, and for your reference, MSnS is an obsolete firmware designation, and does not refer to the actual unit or any hardware. It is MS1 or MSII (or MS3 if you go that route). The firmwares in use are either the original B&G code, or MS/Extra code for those running ignition.
#5386, "RE: MSNS Install " In response to Reply # 6
Back to wiring. Figured out 2 ecu's can't share temp sensors so had to rewire and install some GM temp sensors. The thing runs now and all the sensors read correctly. Now I just need to figure out this whole tuning thing and find a base map that is best to start with.
_____________________________________________ 95TalonOwner on DSMTuners.com Wes Tank on WiDSM.org
#5396, "RE: MSNS Install " In response to Reply # 7
Got my car running somewhat on fuel only on MS. Got all sensors and outputs reading correctly. Last night I noticed my throttle percent randomly jumping around 1-10%. Noisey signal problem?
_____________________________________________ 95TalonOwner on DSMTuners.com Wes Tank on WiDSM.org