Hello everyone, so I finally finished boosting my car and just finished clamping the fcd at 4.75. I get this p0106 and i dont really understand what this code means. Any information on how to go about diagnosing would be much appreciated!
Originally posted by Dstach Try turning the clamp down some more.
Turning it down to what? At what voltage exactly does fuel cut occur? Currently it's at 4.74. Excess information: this only happens after boosting a lot, because i reset the ecu drove with low boost to wawa. After killing it and opening it again no cel. Then i drove it on the highway for a while crazy boosting and killed it afterwards, then the cel came on..
Also i tested the voltages of the fcd with engine off car on sensor unplugged and i got Ground 12.05, green 11.79, red 4.89, orange 4.74, yellow 0.785.
Hopefully, some of the admins can chime in, reset computer, drove a few miles, shut car off, turned on, no issues. Did this 3/4 times. when starting car for 4th time, runs funky and engine light is on. shut it off and start it a few more time, still funky plus cel. Disconnect bettery and plug back in. Runs perfect as if though it wasnt just acting funky a minute ago. could this be a bad computer?
Originally posted by Dstach Try 4.6 volts but keep an eye on your afr.
Lowered it to 4.6 and then even to 4.16, still nothing. Shouldnt this issue be constant? Why does it go away (as well as the funky idle with the cel on) after resetting the ecu?