Well i found this link on neons.org http://forums.neons.org/viewtopic.php?t=223103 and i was wondering how much of a difference is our bellhousing and flexplate from the neons? I know our bellhousing is different but how different is it really? With the neon bhousing the only problem the had was "that the SRT unit was physically too large to fit in bellhousing - The disc would spline up fine but the flywheel was just too big around?" so would it spline up to ours or is it to different. lmk cause i think this would be an awesome and cheap clutch upgrade if it could work for our cars as well. If not, well it was worth finding out
#4698, "RE: Srt4 clutch swap?" In response to Reply # 0 Aug-11-05 04:13 AM by slowmitsu
The unit is far to large for our engine bay. There are plenty of reasonably priced aftermarket solutions that would perform better than anything OEM anyways.
#4701, "RE: Srt4 clutch swap?" In response to Reply # 3
Well we use the same bellhousing as the neon, with exception of the clutch set up (cable VS Hydro), so the size is the same and you would run into the same issue.
I edited to the wiki!
Originally posted by DR1665 NOTE TO SELF: Go commando to wedding. Scar the Irishman for life.
#4703, "RE: Srt4 clutch swap?" In response to Reply # 4
Originally posted by slowmitsu I have no idea if you could get an OEM clutch from an NVT850 to work. I'm just wondering why.
Because the srt4 stock clutch has been known to handle up to 350hp and for being a stock clutch, I think thats not bad. Plus u can find alot of used ones with hardly any miles on them for less then a $100. So it would be a better and cheaper clutch than upgrading to a CM clutch in my mind. Does anyone have a pic of our bellhousing by any chance?
#4707, "RE: Srt4 clutch swap?" In response to Reply # 5
I don't know b/c I haven't researched this at all, but my gut tells me no way. The SRT-4 Neon is a completely different animal than the Eclipse 420A, and I'm sure the tranny's are too. Even if the clutch fit in our bellhousing if it's at all bigger it will knock out the RPM sensor (or speedo sensor - can't remember) and then you'll have a mess.
You're right in theory about it being a cost effective solution, but if it worked it would have probably already been figured out on this board.
#4709, "RE: Srt4 clutch swap?" In response to Reply # 6
I'd like to find an NVG-T850 trans to poke around in. It could even be blowed up. I just want to, once and for all, make the comparisons that people keep asking for.
#4712, "RE: Srt4 clutch swap?" In response to Reply # 8
why is mostly everyone thinking that u have to use the srt4 tranny? What the neon people are doing is using the clutch off the srt4 and making it work on the nv-t350 tranny. hoping to find a srt4 clutch pretty soon to see it would work on our trannys as well since their basically the same thing