| Go back to previous topic | | Forum name | Introductions | | Topic subject | Hub and axle | | Topic URL | http://forums.2gnt.com/dcboard.php?az=show_topic&forum=92&topic_id=584 |
584, Hub and axle
Posted by 2old4-2g, Dec-31-69 06:00 PM
Helping son with engine rebuild. So got that out and he is working on left wheel bearings. Rust hub won’t come off with puller, seems to be a common problem on the list.
So I guess I can just pull the CV Boot and slide the axle out of the trans? No clips or bearings that are going to be a bitch when we put it back in. I have looked on this site but haven’t seen this described.
New to me I haven’t worked on a motor since 1975 and they didn’t put them in sideways. 99, 2gnt
|
585, RE: Hub and axle
Posted by barza21, Dec-31-69 06:00 PM
If you are not able to take the hub out, just disconnect everything else and take the whole thing out, that's how I did it on a neon, but a 2gnt might be different, in regards to the hub removal, the way I did it just use a bar to pop it out, it shouldn't be that difficult, and when you put it in it should just pop in and stay in place.
| |