If its not one thing, its another...

As previously mentioned, Im using a Holset HX40 with a Bullseye Power turbine housing. I opted for the vband adapter BEP sells as well.

Well, BEP hasnt been able to source vband's for a couple months now, so I went outside BEP to buy a vband flange for the downpipe.

The issue now is the 3" inside diameter Vband flange on the BEP housing has a larger outside diameter than the 3" ID flange I bought.

Picture for reference:



The BEP flange has an 3.75" OD

The shop I bought the smaller flange from does not have anything with that size OD -- Does anyone know where I can source a vband flange/clamp with a 3.75" OD?

You might try calling up ATPturbo. I was lookin on there site and I don't see anything specific with a 3.75" OD...but they might be able to source one for ya.


http://www.dsmregistry.com/detail.php?carid=1185

I found a supplier who said they had what I need. Hopefully, they werent blwoing smoke up my ass. If so, Ill repost.

Otherwise, that should be the final purchase before I can get everything on running...