| Go back to previous topic |
| Forum name | Turbo/Nitrous Tech |
| Topic subject | problem big problem |
| Topic URL | https://forums.2gnt.com/dcboard.php?az=show_topic&forum=i8&topic_id=98094 |
98094, problem big problem
Posted by talonized, Nov-06-06 12:03 PM
ok so ive run into many problems when i begin to get boost now first at idle my vaccuum jumps from 18.5 to 20 why??? any ideas?? adn now when the turbo begins to spool it like squeaks loud as if it is not receiving oil!!! but when check it is fine no shaft play nothing oh its a S16G from hahn aside from my fuel issues that is my biggest prob!after driving the car the car turbo doesnt squeel anymore!!!!WTF
|
98095, RE: problem big problem
Posted by clipse_2005, Nov-06-06 12:48 PM
Did you "pre-oil" your turbo before you put it on???
|
98096, RE: problem big problem
Posted by talonized, Nov-06-06 01:25 PM
the turbo was preoiled and everything this is the second motor so the turbo had been used before cant figure out what would cause the turbo to squeel like that!!!! i mean its still spools fine and holds good but why does it soundlike that as for the vacuum fluctuation i cant figure that out either!!
|
98097, RE: problem big problem
Posted by eclipse982nrRST, Nov-06-06 02:37 PM
bad valve seals can cause a vac flux...
i had it in my first stock head. could never figure it out until i replaced them and it was fine...lol
|
98098, RE: problem big problem
Posted by talonized, Nov-06-06 03:28 PM
YEA I DIDT THINK OF THAT HOW HARD WAS IT TO REPLACE?? AND COST OF PARTS!
|
98099, RE: problem big problem
Posted by donnyb373, Nov-06-06 03:50 PM
seals are easy as pulling the cams, springs and pulling the seal...its that easy jsut time consuming and tideous
|