| Go back to previous topic |
| Forum name | Turbo/Nitrous Tech |
| Topic subject | turbo clocking need help |
| Topic URL | https://forums.2gnt.com/dcboard.php?az=show_topic&forum=i8&topic_id=94460 |
94460, turbo clocking need help
Posted by rs_smoked_you, Apr-10-06 05:48 PM
ok so i was clocking my turbo and i put it where i want it( cold side outlet facing down) and the oil feed ended up on the bottom and the drain on top. now can i just on bolt the cold side and tun it over or what cause i dont wanna just go unbiltin stuff and messing it up? tia!!!
|
94461, RE: turbo clocking need help
Posted by BumpinTalon, Apr-10-06 05:52 PM
You need to clock the turbine side now and reclock the compressor side.. you always work from the flange out man
The turbine side is hard to turn, you will probably have to slap a lot of WD40 and penetrating oil on it, and then beat the shit out of it with a hammer to get it to pop off, then you put it back on how you need it and put it back together again.
|
94462, RE: turbo clocking need help
Posted by rs_smoked_you, Apr-10-06 05:56 PM
ok thanks alot man so im not gonna fuck anthing up by takink the cold side off?!
|
94468, RE: turbo clocking need help
Posted by donnyb373, Apr-10-06 08:56 PM
shouldnt iv had mine off probly 4 times now and it still spools like it did from day one..so im going to say go for it
|
94492, RE: turbo clocking need help
Posted by rs_smoked_you, Apr-11-06 03:02 PM
cool thanks guys im so damn close to being done with my set up...all i need is a bov,oil drain,and an exhaust flange/ pipe!! and i should have it in like two weeks!
|