I have new 450's sitting here. I cannot for the life of me find any junkyards around that have the honda resistor box so I don't know if I should keep looking or do the resistor mod thingy.
I already searched and found the write-up on neons.org (Thanks uber)
and I've read every post there is. I totally understand what to do if I were using the 5 wire honda box. (1 ground other 4 to the + side of each injector)

But what I don't understand is.. I can't find 20ohm 50 watt resistors anywhere and don't understand what this is all supposed to look like in the end. Obviously everything should be soldered but...do I solder 2 resistors inline the + wires on the harness?

Pics would be nice. :P

Sell the 450s and get some cheap plug and play 440's. Why bother? :)

Okay, this is stupid.

And almost done. I actually think I figured it out on my own. wO_Ot

20 Ohm.......where did you read that? If you want easy, i have a resistor pack froma 1g with both plugs if you want it.

you need 10 ohm resistors, look for them at digikey.

Terry

I'm using a honda injector box.