Alright so one of my downpipe bolts walked out after driving for a bit and I lost it. So were my downpipe meets my turbo setup is leaking very badly.

I drove around all today looking for a Stud that would work but no place had any, I have a HRC Stage 1 kit by the way.

I did find a place that had a same sized metric bolt that fits perfectly. The downpipe came with 3 studs and nuts, I just wanted to make sure it would be fine if I just used one bolt instead of a stud and nut or would that cause problems? I tryed to search but couldnt find anything.

Thanks
Nick

yeah it should be fine a long as it tightens the dp to the turbo u should be good to roll man

Use a bolt as a temporary solution. DP to turbo fasteners are under lots of stress, a stud should be used. Order one that matches the others from McMaster.

Does anyone know the size of the Downpipe to Turbo stud and nut sizes?

i am sure hahn has them in stock or any speed shop will. just go buy one.

Originally posted by Star Turbo Talon
i am sure hahn has them in stock or any speed shop will. just go buy one.

I will try AMS and some local speed shops when Im back from vacation.

Terry check your PM