| Go back to previous topic |
| Forum name | Turbo/Nitrous Tech |
| Topic subject | Wall clearance and other stuff |
| Topic URL | https://forums.2gnt.com/dcboard.php?az=show_topic&forum=i8&topic_id=84463 |
84463, Wall clearance and other stuff
Posted by TXTurboGS, Mar-30-05 04:56 PM
I am rebuilding my engine and I purchased some Weiseco .040 over pistons. So I am boring the bloc, but I need to know how tight the piston must fit, wall clearance that is. Also, I am using Crower rods, what kind of bearings should I use with them? Any other pertinent info is greatly appreciated. Thanks
|
84465, RE: Wall clearance and other stuff
Posted by RxR_Eclipse, Mar-30-05 05:28 PM
I thought the spec sheets came with the pistons? That would say what your bore should be though.
|
84479, RE: Wall clearance and other stuff
Posted by DarkOne, Mar-31-05 04:31 AM
Originally posted by RxR_Eclipse
I thought the spec sheets came with the pistons? That would say what your bore should be though.
|
84487, RE: Wall clearance and other stuff
Posted by Blizare, Mar-31-05 06:38 AM
yea, they are right.
And AFTER the motor is bored you should get a spec sheet of everything they did to it and the tolerances.
Use Clevite bearings for the crank and the rods imo.
|
84513, RE: Wall clearance and other stuff
Posted by grain, Mar-31-05 04:39 PM
sucks to be you.
|
84524, RE: Wall clearance and other stuff
Posted by TXTurboGS, Apr-01-05 06:46 AM
Why do you say that Grain? LOL. The machine shop wanted to make sure those were the correct specs. It mad eme doubt so that is why I asked. Thanks
|