i have been working on it for about 2 months this is what i have so far

k26 turbo charger
rev hard racing oil feed line and return kit
tial wastegate 38mm
Greddy Blow Off Valves Type S
blow off valve mounting flange
walbro 255lph fuel pump
hks turbo timer type 0
autometer tripile pod
autometer boost gauge
autometer egt gauge
autometer air fuel gauge
custom manifold
vortech sfmu
o2 sensor bung
custom down pipe
1g smic

any thing i missed?

Fuel lines?
Intercooler piping?

Yup, should have a fuel lines (I ran 3/8ths for a new feed, and the original feed was used as a return) and I/C piping. You should also think about a fuel pressure gauge and IMO, an oil pressure gauge. You want to make sure you have adequate pressures of those.

Brian

yeah i do have intercooler piping but on the fuel lines i have read to run braided stainless steel lines and i will be getting a fuel and oil pressure gauge i agree its good to know what is going on with the car

there's a missing link in your setup....or rather isn't a missing link in that list :P...you need some kind of FCD :thumbsup

*edit*

damn...link doesn't work anymore

*edit eleventybillion*

http://www.synapseengineering.com/distributors.html

You don't need the Missing Link with 95'

oh...damn...missed that bit of info. Thanx for correcting me :thumbsup

Originally posted by micyek
oh...damn...missed that bit of info. Thanx for correcting me :thumbsup

and you still have yet to step off the short bus :P