anyone have any install pics of your sfmu? i have searched and found some in the fuel return set up on the site but nothing that is really helping. also what kind of fittings and stuff do you need if you use rubber lines? thanks for the help.

what kind of pictures are you looking for? I just went thru installing mine. I did the return fuel line writeup on the main page. Those pics defintale need updating and the directions could be more detailed.... There is also a fuel supply line writeup. Check those out for pics.

Is this what your looking for?
If your going to run rubber, you can use the same type you use for S/S lines. I would strongly suggest against running rubber line back to the tank though. I had a friend that hit something and his ripped.

Good luck

Here's the return line, with a female clamp-on AN fitting.


There's a male-male adapter on the bottom of the SFMU.


I used 5 fittings total.

90* elbow - rubber fuel in to female AN
3-way tee - male AN to female NPT to male AN
Male-Male - AN to AN for return line outlet
Female - Clamps on to rubber return line
Brass NPT nipple - for fuel pressure gauge

thanks for the pics and the help

Originally posted by DJ420a
Is this what your looking for? If your going to run rubber, you can use the same type you use for S/S lines. I would strongly suggest against running rubber line back to the tank though. I had a friend that hit something and his ripped. Good luck

dayn! how do you keep that engine bay so clean???

one more request for pictures, does any one have pics of where they attached the sfmu to the stock fuel rail and also where the return line is in the engine bay?

Its called, when I have nothing better to do, lol.

Remove the underscore.

http://dirty.thisfreedumb.com/my2gnt/Boosted/images/999_JPG.jp_g

http://dirty.thisfreedumb.com/my2gnt/Boosted/images/Bleed%20Valve_JPG.jp_g