is there a way to get the type s to blow off faster? my waste gate discharges then like a half second later the blow off goes off. also is there anyway to make the wastegate quieter? i know its external(deltagate from star kit), just wondering

route it 18 inches down into your exhaust piping via exhaust shop. quiets it down quite a bit sir.

like weld the dump tube right to the exhaust pipe? will that make my exhuast any louder?

Not really.

Back to your original question, there is a set screw on the top of the Type S to make it blow off softer and harder. I've really paid much attention to it, and I'm sure there is wrong and right way to do it, so you better check it out. But it can be adjusted.

yea i know about that thing, i been adjusting it, i want it to release faster when i left off the clutch. The wastegate releases instantly, the bov is delayed

They probably never be the same or reversed, or whatever you're trying to achieve. Your BOV is releasing excess pressure from the IC to butterfly valve, while to wastegate is operating off of exhaust gas pressures - two complete different things.

Hook up the lower port to your compressor housing. You will need to put 2 O-rings in to seal it up if you do this. Also, Jamesman, (he told me how to do this) said this will only work for below 12psi. Mine works great since I've done this.

so take from the boost part of the compressor housing and run it right to that lower port? What do you mean about the orings exactly, do i open it up and put them inside?

Yes, you have to open it up to install them. You need 2, and they are different sizes. Search for a post I made awhile back about BOV flutter. There is a diagram showing where to put them.