Go back to previous topic
Forum nameTurbo/Nitrous Tech
Topic subjectI need an exhaust flange for the HRC 16g
Topic URLhttps://forums.2gnt.com/dcboard.php?az=show_topic&forum=i8&topic_id=74308
74308, I need an exhaust flange for the HRC 16g
Posted by JustOne, Jul-24-04 10:56 AM
Does anyone have a quick link to a shop that sells a >>2.5id<< three bolt exhaust flange for the HRC turboes?

TIA
Brian
74309, RE: I need an exhaust flange for the HRC 16g
Posted by MetalJim, Jul-24-04 11:25 AM
You can get it from HRC - part #H TZ-7180 - http://www.hahnracecraft.com/hahn/parts/install.htm


95 Eclipse RS : 5 speed
15.7 @ 87.9mph
Jeep TB writeup - http://www.dimensia.com:81/jimbo/JeepTBfor2gnt.html
74459, RE: I need an exhaust flange for the HRC 16g
Posted by thedawg, Jul-27-04 01:28 PM
I'm selling a DIY one. Comes with bolts and paper gasket. It's 2.5" and bolts up to HRC S16G. $20 shipped.



If it helps, it's a standard "Header collector" flange for V8's
74461, RE: I need an exhaust flange for the HRC 16g
Posted by turbo8u, Jul-27-04 01:41 PM
standard 3 bolt flange. RRE sells em i think
74468, RE: I need an exhaust flange for the HRC 16g
Posted by XtremeRS, Jul-27-04 04:14 PM
Just be aware when using a 2.5" flange/gasket size on the 16G/20g turbos, that it leaves like 1/8" or so of actual sealing surface against the turbine housing. Its best to use a 2" or 2.25" ID hole flange/gasket for it to seal well. You may blow gaskets if using a 2.5".. The actual outlet size of the turbo is only 2" anyway.