Ok here 1 of my dyno run videos. i would of had more but my camera died sorry about that. this run was at 11 psi and i put down 226 whp and 214 pds of torque. just click the link
https://home.comcast.net/~actngrezy/videos/dyno_run_internet.wmv

here is the chart for the 13psi run when i put down 244 on the 13psi run

Very nice numbers! Did you also get a printout of your air/fuel ratio when you dynoed? Maybe it is just me and my inexperience in reading dyno graphs, but something looks strange after the 5,000 rpm mark (Does the engine/turbo peak at that point (stops being efficient at making power?).


I have a similar setup (VTEngine's Built Block, HRC Turbo Kit, running 10 psi) and I plan on making a dyno run soon to see how much power it is making. I plan on running 16 or 17 psi daily once I get the fuel curve set.


--Kurt

that run i was running real lean from 5000rpms on. i had to richen up the fuel and turn down the boost a bit. i have found that the fmu is not sufficient at high boost levels so i must install my sfmu but i blew my clutch the car is just sitting now waiting for a spec stage 4