Go back to previous topic
Forum nameTurbo/Nitrous Tech
Topic subject? about way car is running after turbo install
Topic URLhttps://forums.2gnt.com/dcboard.php?az=show_topic&forum=i8&topic_id=70635
70635, ? about way car is running after turbo install
Posted by icedout, May-08-04 03:08 PM
the car runs fine when idleing but if i hit the gas at all it bogs and stalls.... I can slowely press the gas and the idle will go up no problem.... I'm running sfmu w/30lb inj and walbro... any suggestions....
also I have a bad fuel pressure gauge (brand new) doesn't read shit on it... so I can't tell you what the FP is yet.... So i didn't even drive the car yet till I get one to see what kind of pressure i'm running....
70637, RE: ? about way car is running after turbo install
Posted by jsupetran, May-08-04 03:42 PM
Too much gas probably. Fp too hi :shrug


-------jezreel
1998 GS with hrc stage 2, sfmu, ml, prokits, egt, boost gauge, apexi tt, haydans tranny cooler, costum dp, dr. uber groundwires, dynotune fp gauge. gst muff, turbo spoiler
Boostin since Aug 03.

nothing like driving with the windows down and the music low: i love hearing the turbo spool, swwwhhhttt!!!!
thanks for www.kaptainmyke.com for the sig hosting :thumbsup

70639, RE: ? about way car is running after turbo install
Posted by freddy_00_69, May-08-04 04:22 PM
Probably running rich, but also could be not getting enough fuel. I ran the same setup a few months ago and i was not getting enough fuel with the walbro, so i bought an inline and run both pumps and car has been great since. Some cars run fine with just the walbro, but i think inline is alot better. Get a fuel gauge that reads fine and see what your fuel pressure.
70657, RE: ? about way car is running after turbo install
Posted by Justin99RS, May-09-04 04:30 AM
sound like way to much fuel...i'm having the same problem now that i removed my turbo...still trying to figure out which part to change..