Well I figured I'd give you all an update on my Megasquirt instal...

I haven't actually worked on it much this last week, havent had the time this week... but here's what I did get done...

The wiring harness is complete.
The Megasquirt itself is complete.
I have GM Intake and Coolant temp sensors. This will make it so much easier to setup the system... I don't have to worry about using the Chrysler sensors and the changes that their use would entail.
I have an injector harness which I have to modify yet.

So basically if I have the time this week I'll get everything installed in the evenings... should only take an hour or so to install it all.... And then it will be time to start her up... heh.

Hmmm, although I just reembered that I need to get a fuel pressure regulator yet... although if I wanted to I could run it with the rising rate regulator just to see if she runs... }(

Does anyone have a 1:1 regulator that they want to get rid of???

would you put it on the car already mang!

and then send me humoungus pics so i can upload em.

Originally posted by MotoFool
would you put it on the car already mang! and then send me humoungus pics so i can upload em.

Actually I was gonna say can someone host pics for me... :thumbsup

The problem is I work 50 miles from home, and by the time I get home it's late... doh!

So it will probably wait untill this weekend for install... unless I feel like going down to my buddys garage...

I think today I'll "make" my 1:1 FPR.... heh... could be interesting....

Originally posted by MrSlick
I think today I'll "make" my 1:1 FPR.... heh... could be interesting....

:o

Keep us updated. I can host pics for you, you can just upload them to my anon ftp.

Originally posted by etx

Originally posted by MrSlick I think today I'll "make" my 1:1 FPR.... heh... could be interesting....

:o Keep us updated. I can host pics for you, you can just upload them to my anon ftp.

Sweet... give me the details and I'll send some up later...

Cheers! :cheers