Does anyone here have a Chill Factory downpipe with their HRC turbo? I am in the market for a new 3" DP. Thanks for any info

I don't know of anyone ordering one yet. I think you would be the first but I can't back that up.

I have one for my custom turbo. It made a HUGE differance over my "stock" one.

babyeclipse has one but I think he is running a t3 turbo.

ya, but he has a replacement for the Hahn kit that makes it 3in }(

Excellent. I'm going to give him a call. Thanks

Anytime

You prob won't be able to bolt a 3" DP to the HRC Super series turbos. First thing, is that the flange needed can really only take at most a 2.5" pipe. This would mean that you would need to fab a reducer to mate to the flange, then up the pipe size to 3". Next issue is that there will be almost NO room to run a 3" DP, mostly because the A/C pump and lines get in the way. If you ditch the A/C system, then it can be done. Next issue is the 3" pipe clearing the radiator fan, then at the same time, clearing the coolant crossover pipe. IMO, all these issues isn't worth putting a 3" DP on, at LEAST not right at the turbo outlet. Maybe go 2.5" turbo out, then after it shoots downward past the clearnce issue spots, then go up to 3". Its VERY tight in there..I should know, since I made 10+ custom 2.5" HRC DP's..this is assuming all mandrel bent piping also..I really don't think 3" is necessary until you are really pushing some big power...400+ crank HP..Any differences from 2.5" to 3" will be mostly spool up rpm, which you may get a 100 or so, but power gains will be minimal if you aren't pushing lots of boost/power..I gained mostly spool up time going from a stock DP to the 2.5" at 13 psi. Approx HP gain around 5-10 HP. Got around 250 rpm spoolup though :)