Ok here is what i have no inline pump... walbro 255, 30lb injectors, and the sfmu... ok i have the supply all hooked and configured.... now where do i go with the return..... I don;t have the setup like the HRC kit... with going all the way back.... so where do i tap into the return... run a line back or is there an easier way... and i also don;t have the fuel setup from hrc so that is why i went this way...
thanks.... :thumbsup

look up whodatt's sfmu write up on the sfmu install. its on the mods page, and he has a lot of pics so you know where the fuel return line will be.

fuel return line: open up the tank access panel in the rear seats. you will see a hard line (thats coming from the tank-that the feed line), and the soft line (its maller-that the return line). on port at the bottom of the sfmu, that's the return line. you run a line under the car, then connect this to the soft line, and that will be your new return line. look around the car for a while and you will know what i mean, but check out whodatts write up too.

-------jezreel


hrc stage 1, sfmu, ml, prokits, egt, boost gauge, apexi tt, costum dp, dynotune fp gauge. gst muff, turbo spoiler

nothing like driving with the windows down and the music low: i love hearing the turbo spool, swwwhhhttt!!!!

ok so i do have to run a line... i thought for some reason there was another way of doing it without running it all the way back... i guess i was confused with it...
Thanks bro.....